RAMSET GypFast G2 Provozní pokyny stáhnout pdf (Strana 10)

FUEL CELL AND METERING VALVE

INSERTING FUEL CELL

With the Metering Valve Stem pointed toward the

front of the tool, insert the Metering Valve/Fuel

Cell Assembly.

As you slide the Metering Valve/Fuel Cell Assembly

into the GypFast (G2) tool, you will notice that there

is a Red Adaptor at the top of the Cylinder Pocket.

As is shown in the illustration, this Adaptor is designed

to ensure that the Metering Valve Stem is properly

aligned with the small hole, or orifice that leads to the

Combustion Chamber. Insert the Metering Valve

Stem into the orifice of the red colored Adaptor.

You complete the loading of Fuel Cell in the

GypFast (G2) tool by closing the Actuator Cover.

You do this by swinging it up and over the Fuel

Valve/Cylinder Assembly and pushing down until

the Actuator Cover snaps into position.

OUTDOOR WEATHER AND THE

GypFast (G2) TOOL

Use the GypFast (G2) tool outdoors, in clear weather,

when the Tool, Fuel Cell, and Battery are between

20°F (-7°C) and 120°F (49°C). Colder temperatures

may damage the GypFast (G2) Tool and Battery. Hotter

temperatures may damage the Tool and Fuel Cell.

Fuel should be stored out of direct sunlight in

surroundings less than 120°F (49°C). After extended

periods of continuous use, cool the Tool by running

the Fan Motor.

Operation when the Tool is less than 20°F (-7°C) may

damage the tool. Fuel Cells at cold temperatures

lose the required propellant force. Bring the Tool,

Battery, and Fuel Cell above minimum operating

temperature without direct exposure to flame, and

check the Battery.

CAUTION

The GypFast (G2) tool should not be used in the

rain or where excessive moisture is present.

These conditions may result in damage to tool

components and cause tool to malfunction.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Žádné komentáře

RAMSET GypFast G2 Provozní pokyny Strana 10