RAMSET Viper Tool Uživatelský manuál Strana 1

VIPER TOOLOPERATOR’S SAFETY & OPERATING INSTRUCTION MANUALDANGERTHIS TOOL FOR USE BY LICENSED OPERATORS ONLY.READ AND OBEY ALL SAFETY AND OPERATIN

4. Lower the tool, keeping it pointed in a safe direction, and insert the next fastener or fastener assembly. Note: While the Viper tool is being c

REFER TO PARTS SCHEMATIC FOR PROPER ASSEMBLY OF PARTS– Overdriving of fasteners – Excessive power – Change to the next lower power level

PARTS SCHEMATICPARTS SCHEMATIC 12DIAGRAMA DE PIEZASDIAGRAMA DE PIEZAS12

PARTS LIST / MAINTENANCE PARTS LIST / MAINTENANCE 13Always make sure the tool is not loaded before performing any service or rep

DISASSEMBLY 14DISASSEMBLYTOOL DISASSEMBLY1. Unscrew and remove the barrel retention collar. Handle the tool carefully after the collar is unscrewe

DISASSEMBLY 15DISASSEMBLY 6. Remove the buffer from the muzzle bushing. Inspect all parts for wear or damage and clean or replace as

VIPER WARRANTY AND LIMITATIONSPOWDER ACTUATED TOOLMANUFACTURES' INSTITUTE INC.TMConcrete Fastening SystemsGlendale Heights, IL 60139 800-RAMSET6

Just as no one can merely read a book about driving an automobile and then hope to drive one safely, no one should attempt to use any Ramset tool wi

PreparationAcceptable Base MaterialsPowder actuated fastening is suitable for use in the following base materials only:• PouredConcrete• Structural

Loads & Load Selection Safety1. Always make a test fastening after being sure that the base material is suitable for powder actuated fastening

Tool Handling Safety1. Always be sure tool is operating properly before attempting to use it. Follow the “Daily Function Test” shown to the right an

FAILURE TO FOLLOW INSTRUCTIONS CAN CAUSE INJURY TO THE TOOL OPERATOR OR TO BYSTANDERS.Fastener Driving Safety1. Only use the tool for fastening into

Your Ramset Viper Tool uses only the Ramset fasteners and loads shown below or listed for the tool in the Product Catalog.FASTENERS AND FASTENER ASSE

FASTENING APPLICATIONSYour Ramset tool can be used for a wide range of fastening needs in a variety of base materials. Reading and follow these impor

TOOL OPERATIONDAILY FUNCTION TEST Always check the tool first to make sure that it does not contain a load strip or fastener. Test the tool overhead s